Detect Wetness with RFID

The HUM-ID system consists of two components: a wetness detector - the sensor - and a reading device - the scanner. Both components can communicate with each other through different superstructures. The solution is based on the latest RFID technology.

Send inquiry

Detect Wetness with RFID

The HUM-ID system consists of two components: a wetness detector - the sensor - and a reading device - the scanner. Both components can communicate with each other through different superstructures. The solution is based on the latest RFID technology.

Small sensors - big effect

RFID chips are used for identification and localization in many everyday applications. The wireless sensors also use this transmission standard, but are also able to detect wetness. Wirelessly and without a permanent power supply, they transmit this information to the reader.

The products
Wam roof
Cold roof
Green roof
Flatroof with photovoltaics
Wet rooms
Underfloor heating
Balconies / terraces
Kitchen waterproofing

Endless
possibilities

The HUM-ID sensors are the standard for flat roofs. The high flexibility, accuracy and signal strength enable an efficient and cost-effective leakage check - without having to open the roof. The wireless check for wetness and standing water is now also used in many other applications.

Send inquiry

The proof: The component is dry.

HUM-ID is already used for acceptance - as electronic proof of tightness. Once installed, the sensors can be queried at any time - either by facility management or by the processor. Thanks to the simple operating concept, no specialist personnel are required to check the sensors.